unique engine bolt kit for predator engines and the correct anti vibration pilot washer. 10 tooth sprocket for a 40/41 chain and a 12 tooth sprocket for a 35 chain. small engine clutch that is nearly the same as a Comet TAV2 30 75 Torq A Verter A torque converter acts similar to a transmission, allows higher speeds out of your small engine, and smoother acceleration Engagement range is approximately 2350 RPM
This is for 1 brand new complete 6.5 HP (212cc) OHV Horizontal Shaft Gas Engine Torque Converter with all hardware necessary to mount. Important Note: Included is the unique engine bolt kit for predator engines and the correct anti vibration pilot washer. Predator engines have a shoulder at the crank that is off by which cause the driver to rub on the back plate and misalignment of the belt; We provide extra piece of hardware to fix the problem. (no other kit on the market provides everything needed to fit a 212cc predator engine). This kit comes with either a 10 tooth sprocket for a 40/41 chain and a 12 tooth sprocket for a 35 chain. Bullet Lines torque converter is an asymmetrical inline small engine clutch that is nearly the same as a Comet TAV2 30 75 Torq A Verter. This clutch will help you get more power out of your small engine by reducing engine load. A torque converter acts similar to a transmission, allows higher speeds out of your small engine, and smoother acceleration. Small engine Torque Converter clutches are heavily used in riding lawnmowers, small tractors, go karts, mini bikes, mini choppers, ATV, motorcycles, and waterski winches. Engagement range is approximately 2350 RPM; however, this can be adjusted from Minimum 1200 RPM – Maximum 3100 RPM by changing out springs (not included) and other adjustments.  Our torque converter fits a 3/4″ shaft and comes with a 10 tooth sprocket for a 40/41 chain and a 12 tooth sprocket for a 35 chain. Engine compatability:  Predator 6.5 HP (212cc) OHV Horizontal Shaft Gas Engine. Specifications: Driven unit: Diameter 6″ (157mm) with 5/8″ bore Drive clutch bore: 19mm (3/4″) Belt: Asymmetrical type Belt Top width: 19mm(3/4″) Sprocket teeth: 10 teeth or 12 teeth Engagement range: 2350??200 RPM Recommended engine: 5.5HP – 9HP engine, 3/4″shaft with flat key