Search Results for: go kart engine with reverse gearbox

8HP Reverse Gearbox Fits 6.5HP Go Kart Engine 25mm 12T #35 Sprocket TAV 30

Model Number 12T 25mm #35 TAV30
Type Go Karts Accessories, 12T 25mm #35 TAV30 Reverse Gearbox
Certification CE
Engine 4 Stroke, 2-8HP
Drive Mode Chain Drive
Wheel Size 10×4.50-5/11×7.10-5
Oil Tank Capacity 10L
Maximum Speed 60km/h
Displacement 50-200cc
Brake Type Hydraulic Brake
Engine Capacity 50-200cc
Forward Ratio Speed 0.0423958333333333
Reverse Ratio Speed 0.043125
Chain #35
Teeth 12T
Application go kart, ATVs

Go Kart Forward Reverse Gearbox for 2HP-13HP Engine #35 12T 30 Series Torque Converter

Name 12T #35 Go Kart Reverse Gearbox
Model Number Go Kart Reverse Gearbox
Type Go Karts Accessories
Certification CE
Engine 4 Stroke
Drive Mode Chain Drive
Wheel Size 10×4.50-5/11×7.10-5
Oil Tank Capacity 10L
Maximum Speed 60km/h
Displacement 50-200cc
Brake Type Hydraulic Brake
Engine Capacity 50-200cc
Sprocket Size 12T #35 sprocket
Horsepower 2-13 hp
Work With TAV30 Torque Converters
Fits For go kart
Chain number #35
Shaft Size 5/8″ with 3/16″ keyway
Forward Ratio 1??1.3
Reverse Ratio 1??2.6

Voltage Regulator Rectifier for Yamaha XV400 VIRAGO 3JB XV1100

Category: Three-phase full-wave rectifier 7 wires
Output voltage: 14.5+—0.5V

Applies to:
3LP-81960-00-00
42X-81960-A1 42X-81960-A1-00 SH569A-12
Yamaha XV400 TW125 XG250 5XT
Yamaha VMax VMX1200 1985-1995
Yamaha XV 1000 Virago 1984-1985
Yamaha XV 1100 Virago 1986-1996
Yamaha XV 535 Virago 1987-1996
Yamaha XV 700 Virago 1984-1987
Yamaha XV 700 C Virago 1986
Yamaha XV 700 S Virago 1986
Yamaha XV 750 Virago 1988-199

Universal 350 watt/30 amp golf cart DC converter

350 WATT/ 30 Amp
Used on all electric golf carts
Converts a direct current voltage from a different voltage level to another 48V-12V — 36V-12V
High quality internal parts.
Water Resistant.
Instructions included.
Mechanical / Electrical knowledge is encouraged when installing this unit.
Make sure this is the part you need, no returns accepted.
The electrical pigtail comes from the factory, you will need to cut and splice according your application.