Comet Torque Converter kits are used in small vehicles, riding lawnmowers, small tractors, go karts, mini bikes, mini choppers, ATV, motorcycles, and waterski winches. Torq-A-Verter Comet Torque Converter 30 Series small engine belt drive pulley clutch kit will help with more take off power, smoother acceleration, climbing ability, and top end speed by providing more torque in the low end and higher speeds in top end. Go Kart Torque Converter Kit is a direct replacement and fits all models of Comet TAV2 Torq-A-Verters 218353A, 219552A, 219456A, 217610A, and 203814A 30-75 . Vehicles currently using a centrifugal clutch can easily upgrade to a bolt on TC2 torque converter saving money from burned up CC units Comet 30 Series Torque Converter kit bolts on to most engines with a horizontal shaft including: Briggs, Clinton, Honda and clones, Kohler, Lifan, Robin, and Tecumseh motors. Driver clutch bore: 1″(24.5mm),Driven unit: Overall Diameter 6″ (5/8″ driven pulley) ,Sprocket teeth: 10 teeth #40/41 chain. WARNING – IF YOU PURCHASE THIS KIT AND BURN THROUGH BELTS, THEN YOU HAVE PURCHASED THE WRONG SERIES TORQUE CONVERTER. ALSO – THIS UNIT DOES NOT NEED OR COME WITH THE BRONZE IDLER BUSHING: THIS PART IS ONLY FOR THE 3/4″ KIT. THIS KIT MAY NEED MODIFICATION TO FIT YOUR ENGINE – NONE OF THE REASONS ARE A DEFECT, AND WE WILL DISPUTE FOR NO REFUND.
Bullet Lines 1″ torque converter replaces Comet TAV2 30 – 100 Torq-A-Verter models 218354A, 218355A TAV2 30-75. It is also is a replacement for Yerf Dog, Manco, Carter Brothers, Cushman Scooters, and more Bullet Lines 1″ go kart clutch is an asymetrical inline small engine clutch that replaces Comet TAV2 30 – 100 Torq A Verters. This clutch will help you get more power of your small engine by reducing engine load with nearly a 10 – 1 overdirve. A torque converter acts similar to a transmission, allowing higher speeds of your small engine, and smoother acceleration.Small engine Torque Converter clutches are heavily used in riding lawnmowers, small tractors, go karts, mini bikes, and waterski winches. This torque converter fits a 1″ shaft and comes with your choice of a 10 tooth sprocket for a 40/41 chain or a 12 tooth sprocket for a 35 chain. It will work with small engines producing 8 HP – 13 HP Model 1: 1″ Bore, 35 Chain, 12 Tooth Model 2: 1″ Bore, 40/41 Chain, 10 ToothEngine compatability: Bullet Lines Torque Converter is compatible on most engine with horizontal shaft.Specifications:Driven unit: Dia. 157mm Drive clutch bore: 1″ Belt: Asymmetrical type Top width: 19mm(3/4″) Sprocket teeth: Choice of 10 teeth or 12 teeth Engagement range: 2350??200 RPM Recommended engine: 8HP – 13HP engine, 1″shaft with flat keyThe Torque Converter assembly includes:Driver Unit:1set Driven Unit:1set V-Belt:1pc Driven Shaft & Gear:1set Side Retainer Plate:1pc Torque Converter Cover:1pc InstructionsAll respective trademarks and registered trademarks appearing on this website belong to their respective ownersProduct does not need bronze idler bushing.