The power supply of a motorcycle is mainly composed of a battery, an engine and its regulator or a magneto. Pay attention to the following points when maintaining and using the power supply:
A.When installing, put the battery on a level surface, then you must remove the vent cap, use a special tool to remove the liquid injection port, add electrolyte, the electrolyte should be added to the top dead center and the bottom of the battery Between dead ends. After the electro-hydraulic is added, it can not be loaded blindly. It is better to charge the electricity, then install the car and start the motorcycle with your feet?
B. Continuously press the power start button for 5 seconds and the start is not successful after 15 seconds before restarting, otherwise it will damage the ring battery.
C. When the motorcycle runs for a period of time, the electrolyte will drop. Always check whether the electrolyte is sufficient. If it is below the liquid level, it should be supplemented with purified distilled water in time (absolutely no electrolyte and tap water, spring water, etc.).
When the car is not used for a long time, the battery should be removed from the car and recharged once every two months. During the recharge, the sealing cover should be removed to prevent the explosion of the charge.